Garage door won't close: sensor repair in Bridgewater

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (908) 332-8550

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Bridgewater realigns or replaces the sensors and tests the safety reverse.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Bridgewater

In Martinsville, up on the Watchung ridges, driveways slope and garages collect whatever washes down them, so sensors get wet, muddy and knocked by snow shovels. In Bradley Gardens, Finderne and Green Knoll, the garages are mostly attached two-car spaces in daily use, and a door that reverses is usually a bracket out of line or the close limit touching down too hard after the slab has settled. Around Sunset Lake, moisture on the lenses on cool mornings causes the same symptom.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

What the technician does

  1. Checks power and wiring to both sensors and repairs any break.
  2. Realigns the sensors, or replaces the pair if one has failed.
  3. Resets the open and close travel so the door seals without straining.
  4. Tests the automatic reverse on an object in the doorway and with the beam blocked.

Around Bridgewater

  • Finderne: Older homes on the river plain near Manville.
  • Bradley Gardens: Capes and ranches in the southwest near the Raritan.

See the full Bridgewater service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (908) 332-8550
Call (908) 332-8550